Hello peeps,
Number One Student Back Again (still learning at 50yrs old).
VIN: WVWZZZ1KZ8W163398
Type: 1K1 B6B
Engine code: BKD
Transmission: KDN
This car starts fine every time the dies after 2 seconds. The car had a windscreen fitted about 5 days before this problem started and it was a real shitty job, Glass left everywhere etc. I'm not sure if this relevant but am supplying as much info as I have.
DTC's are 05488 ECM disabled
05712 DataBus missing message from Instrument Cluster
49478 Lost Comms with gateway A
05687 DataBus drivetrain missing message F.Central Elect.Control
05785 DataBus missing message from Steering Column Electronics
05685 DataBus drivetrain missing message from A/C control module.
These DTC's were supplied buy the customers local garage who must have either a KTS diagnostic tool or VAS.
Because my Delphi 150 wont obtain comms at all with any of the cars control units.
Now I might be barking up the wrong tree but in my experience? No comms has usually come down to a Power or Earth supply issue to the main ECM . I've not started any testing yet but I have all the technical info to hand.
I just wanted to know if this rings any bells with you Pro's.
Regards
Paul
Number One Student Back Again (still learning at 50yrs old).
VIN: WVWZZZ1KZ8W163398
Type: 1K1 B6B
Engine code: BKD
Transmission: KDN
This car starts fine every time the dies after 2 seconds. The car had a windscreen fitted about 5 days before this problem started and it was a real shitty job, Glass left everywhere etc. I'm not sure if this relevant but am supplying as much info as I have.
DTC's are 05488 ECM disabled
05712 DataBus missing message from Instrument Cluster
49478 Lost Comms with gateway A
05687 DataBus drivetrain missing message F.Central Elect.Control
05785 DataBus missing message from Steering Column Electronics
05685 DataBus drivetrain missing message from A/C control module.
These DTC's were supplied buy the customers local garage who must have either a KTS diagnostic tool or VAS.
Because my Delphi 150 wont obtain comms at all with any of the cars control units.
Now I might be barking up the wrong tree but in my experience? No comms has usually come down to a Power or Earth supply issue to the main ECM . I've not started any testing yet but I have all the technical info to hand.
I just wanted to know if this rings any bells with you Pro's.
Regards
Paul