2008 VW Crafter auto shift manual transmission 157.000 miles.
Problem: unable to complete programming after clutch replacement = no drive.
I tried with VAS5052A and VAS-PC/VAS5054A same result failed comms on engine start hangs the process with just the grid learned.
Solution:
I connected Mercedes Star Diagnosis/Xentry and selected Sprinter 3 906 and scanned.
EIS profiled the vehicle as VAG.
I selected Transmission and adaptations to learn.
Problem: ignition on/off not recognized by tester
Solution: terminal 15 supply connected into pin 8 diagnostic socket = OK
Adapt clutch process completed correctly.![evilgrin evilgrin]()
Just a shame it couldn't fix the worn synchro on 3rd.
Problem: unable to complete programming after clutch replacement = no drive.
I tried with VAS5052A and VAS-PC/VAS5054A same result failed comms on engine start hangs the process with just the grid learned.
Solution:
I connected Mercedes Star Diagnosis/Xentry and selected Sprinter 3 906 and scanned.
EIS profiled the vehicle as VAG.
I selected Transmission and adaptations to learn.
Problem: ignition on/off not recognized by tester
Solution: terminal 15 supply connected into pin 8 diagnostic socket = OK
Adapt clutch process completed correctly.

Just a shame it couldn't fix the worn synchro on 3rd.
